11-22-2020, 07:37 AM
(11-05-2020, 01:55 AM)rAi Wrote: I could not get any of the previous links to work on a relatively new Mars. Starting around eary 2020 they shipped with Firmware v4.3.x and that version does not run the .photon files.
Therefore, I created a new set of test prints that span exposures from 1 to 20 s in one shot.
You can find how to use them and extend them at https://github.com/r-a-i/mars-resin-xp-finder
I have purchased the Elegoo Mars 2P this month- great machine! running V4.3.9... Im interested in calibrating various resins prior to printing, so need a good workflow.
The gcode files to put into print mode seem to work ok, but the .cbt file are not valid on this firmware. I have managed to re slice the original file in CHITUBOX following the settings in the readme (attached). I dont know how to create the multiple files using 010 editor - but Im not that bothered as I only want a couple for 50 micron no AI, so I created a single 50 micron file. It only prints the rectangular base without any features. I set the layer height 0.05mm - should this be 1mm as per below.? Im not sure the editor changes this..
other than this test it prints fine using the ABS like Elegoo grey Im using. My exposure is ok, and repeatable prints. It mainly for other resins Im about to try..