10-26-2019, 05:18 AM
The problem is not directly the set=0 but that the reference point is not equal to the build plate zero point, but much more important that the drive motor and the damper give way differently, especially when the axle drives on a block. That's why I developed the adjustable Z-axis to adjust the reference point so that NO more force is applied to both the engine and the damper. With 2 sheets set the light barrier as distance and then go up 0.2mm and with SET=0 set the build plate.
Translated with www.DeepL.com/Translator
Translated with www.DeepL.com/Translator