12-03-2019, 07:39 PM
This thread is so confusing to me. I haven't noticed any problems with my prints...how do i know if i have a z- height problem? I don't know mechanical stuff well so if I do have a problem I don't understand what all these washers are and their serial numbers or where to even find such things. Then even after I would find them how I am to install. I know alot of this probably seems simple to you all but that isn't the case forme. I have read a few of the "step by step" tutorials on what to do to fix but they skip alot that they just assume the person watching shoulld know.