01-19-2020, 02:04 AM
I was 1mm of on my 20mm calibration cube, and after I followed this tutorial nothing sticks to my build plate any more 
I first did a 1mm adjustment and then after a failed print, I redid z=0 with 0.5mm adjustment, and still nothing sticks...
Now going to clean the vat again and remove the stuck resin from the fep and then I am going to try just 0.02mm and see what happens. Cross your fingers for me.
I first did a 1mm adjustment and then after a failed print, I redid z=0 with 0.5mm adjustment, and still nothing sticks...
Now going to clean the vat again and remove the stuck resin from the fep and then I am going to try just 0.02mm and see what happens. Cross your fingers for me.