01-19-2020, 03:35 AM
(01-19-2020, 02:04 AM)SnyggJohan Wrote: I was 1mm of on my 20mm calibration cube, and after I followed this tutorial nothing sticks to my build plate any more
I first did a 1mm adjustment and then after a failed print, I redid z=0 with 0.5mm adjustment, and still nothing sticks...
Now going to clean the vat again and remove the stuck resin from the fep and then I am going to try just 0.02mm and see what happens. Cross your fingers for me.
i havent had a chance to update the instructions, but if you have more then 0.4mm - 0.5mm of offset, more then likely, the stepper only has a single spring washer installed and needs to be modded with the washer, or have another spring washer installed.