12-24-2019, 06:59 AM
I did the FAN off mod to the settings.
Power is measured on mains side 230V AC,
Idle after power on 3.5 W
Start print motor move down, FAN started 9.5 W
UV ON, FAN on 52.6 W
motor up/down FAN on, while printing 8-9 W
Idle after print motor is up, not moving 7 W
the settings do not alow for motor off and fan off at the same time..
WHY NOT ?? what is the point to burning 4 watts into the motor and motor driver after a print is done ??
Firmware change request.. thanks..
Power is measured on mains side 230V AC,
Idle after power on 3.5 W
Start print motor move down, FAN started 9.5 W
UV ON, FAN on 52.6 W
motor up/down FAN on, while printing 8-9 W
Idle after print motor is up, not moving 7 W
the settings do not alow for motor off and fan off at the same time..
WHY NOT ?? what is the point to burning 4 watts into the motor and motor driver after a print is done ??
Firmware change request.. thanks..
OZ2CPU Thomas Scherrer Denmark webx.dk
Thingiverse : OZ2CPU Youtube : Thomas Scherrer
3D printers : Elegoo Mars and Creality CR10S PRO
Thingiverse : OZ2CPU Youtube : Thomas Scherrer
3D printers : Elegoo Mars and Creality CR10S PRO