04-10-2020, 01:34 PM
I think I have spotted a caveat with this that needs to be put in the instructions - First time I tried running the gcode, the build plate was about half way up, and after completion, it maxed out the z-axis, grinding the motor. It seems like it resets z=0 during installation and tries to home z to full height from there.
Should the instructions say to put your build plate to zero (level it) before running? I tried that a second time and it correctly stopped at the right max-z height.
Should the instructions say to put your build plate to zero (level it) before running? I tried that a second time and it correctly stopped at the right max-z height.