04-11-2020, 01:38 PM
Good Afternoon All,
I had some issues with the Z axis jamming when repeatedly printing the same items.
Now before starting a print, I run the platen down to the FEP layer, then back to the top(up x 15 x 10mm).
This appears to spread the lubrication and also detects most Z axis issues BEFORE the printing begins.
Happy Printing,
Bruce
I had some issues with the Z axis jamming when repeatedly printing the same items.
Now before starting a print, I run the platen down to the FEP layer, then back to the top(up x 15 x 10mm).
This appears to spread the lubrication and also detects most Z axis issues BEFORE the printing begins.
Happy Printing,
Bruce