09-24-2020, 10:07 PM
I just got the mars pro today
Place paper in lcd
1. Loosen the bolts for the build plate leveling
2. Hit home button
3. Hold down plate and tighten bolts.
4. set z=0
5. Re-home, press the home button again.
6. Check paper tension, my paper wouldn't move,
going up 0.1 achieved correct tension
7. Loosen bolts and re-home, now before tightening bolts, send the built plate down 0.1, and tighten the bolts.
8.set z=0
9. Re-home
10. Paper tension is now perfect at home position, because I compensated for it.
I hope this made sense. It worked for me. Your mileage may vary.
Place paper in lcd
1. Loosen the bolts for the build plate leveling
2. Hit home button
3. Hold down plate and tighten bolts.
4. set z=0
5. Re-home, press the home button again.
6. Check paper tension, my paper wouldn't move,
going up 0.1 achieved correct tension
7. Loosen bolts and re-home, now before tightening bolts, send the built plate down 0.1, and tighten the bolts.
8.set z=0
9. Re-home
10. Paper tension is now perfect at home position, because I compensated for it.
I hope this made sense. It worked for me. Your mileage may vary.