Pro Has No Adjustment for the the HOME Position?

[Quacker]

I was surprised to find that on my new Pro, when I adjusted the starting point with paper, and pressed Z=0, it did not change the HOME point. Without this feature, it is impossible to check and see if the Z=0 has been done correctly or if it has shifted. Someone on a FB forum said that there was a G-Code hack for the non-Pro version that would allow this to work. Is there a G-Code hack for the Pro?

One of the other problems that not allowing a change in the HOME position has caused was when I installed this vinyl seal:

https://www.amazon.com/gp/product/B081D4...UTF8&psc=1

This seal is just thick enough that it stalls the Z motor when pressing the HOME button. Not amusing. So it is obvious that there needs to be some way to adjust the HOME point.

Thanks for any wisdom you can share -