03-22-2020, 03:10 PM
Hi everyone,
I'm new to the forum. I've had my Mars for about a month and a half.
I've been able to print the rooks successfully, and one other thing...once.
I've been struggling with prints sticking to the FEP. I've tried replacing the FEP, I bought the Elegoo 2 pack of resin tanks (FEP installed), I'm using Elegoo Grey Resin. I've even tried the 3-in-1 wiped on the FEP.
I've leveled the build plate prior to printing using a piece of paper per the instructions...
I'm including a picture of my current project in CHITUBOX and a screenshot of my settings.
Could someone tell me if something looks incorrect?
I tried making more of these guns in an attempt to add more surface for the build plate but it hasn't helped.
Any suggestions would be appreciated. Thank you!!
I'm new to the forum. I've had my Mars for about a month and a half.
I've been able to print the rooks successfully, and one other thing...once.
I've been struggling with prints sticking to the FEP. I've tried replacing the FEP, I bought the Elegoo 2 pack of resin tanks (FEP installed), I'm using Elegoo Grey Resin. I've even tried the 3-in-1 wiped on the FEP.
I've leveled the build plate prior to printing using a piece of paper per the instructions...
I'm including a picture of my current project in CHITUBOX and a screenshot of my settings.
Could someone tell me if something looks incorrect?
I tried making more of these guns in an attempt to add more surface for the build plate but it hasn't helped.
Any suggestions would be appreciated. Thank you!!