03-23-2020, 05:56 AM
(03-23-2020, 03:25 AM)fromFDMtoSLA Wrote: did you read the entries, tipps and hints in this forum section: Prints Sticking to the FEP Film ?Yes. I saw a post about sanding the build plate (I've seen that elsewhere as well) and then a response advising against it. I've also seen posts about suing 3-in-1 lube (tried it) and RainX.....
I've seen where folks say increase the exposure time for the first layer...tried that too....
My post was more about, does something look wrong? Since I'm new, there may be guidance on how best to place prints for sticking to build plate. There may be something in my settings that look off.
Thanks