03-24-2020, 04:58 AM
(03-24-2020, 01:59 AM)fromFDMtoSLA Wrote: my steps, i would do in this situation:
- cleaning the build plate and the fep (inner and outer) with IPA
- sticking capton tape around the lcd and clean the lcd (dry towel)
- leveling with a stack of two pieces of paper (witout the vat)
- rotate one of the parts to get a bigger surface on build plate
- increase the exposure time (a little) up to 80sec base and 10 sec layers
but this is only my way to check ;-)
Thank you for the reply! Last night I tried one of the Artisian's Guild Pre-Supported files (Patreon) and it worked!
I'm thinking it has to do with my model. I'm going to try more today. I actually tried another (single) of my model this morning but the printer sounded like it was grinding, so I'm assuming there is something in the resin vat from last night's print. I'll clean that out and try again...If I still have problems I'll try the kapton tape and the two pieces of paper for leveling and see how that goes!
Thanks again!