Elegoo 3D Printers Forum › Elegoo Mars 3D Printer › Firmware Updates v
Update Problem

 
Thread Rating:
  • 0 Vote(s) - 0 Average
Thread Modes
Update Problem
Seaking406 Offline
Junior Member
**
Posts: 7
Threads: 3
Joined: Jun 2020
Reputation: 0
#6
07-05-2020, 05:07 PM
(06-13-2020, 01:59 AM)cliffyk Wrote: "M18*" is of the newest series, your 4.3.2 firmware is the latest--it has not even been released as an upgrade yet...

That was a surprise, thanks!  Printer is working out great, many successful prints, only one major failure due to user error (too thin supports) but other than that, what a great resin printer!
Find
Reply


Messages In This Thread
Update Problem - by Wolf - 04-19-2020, 05:50 AM
RE: Update Problem - by fromFDMtoSLA - 04-19-2020, 11:18 PM
RE: Update Problem - by fromFDMtoSLA - 05-13-2020, 09:01 AM
RE: Update Problem - by Seaking406 - 06-06-2020, 12:01 AM
RE: Update Problem - by cliffyk - 06-13-2020, 01:59 AM
RE: Update Problem - by Seaking406 - 07-05-2020, 05:07 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)