05-10-2020, 12:13 AM
remove the moisture and check the FEP about a damages. Somtimes there are some small holes in the FEP, so your "moisture" can be resin.
|
Cracking sounds during print.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Cracking sounds during print. - by IllDante - 05-07-2020, 10:19 AM
RE: Cracking sounds during print. - by fromFDMtoSLA - 05-07-2020, 10:29 PM
RE: Cracking sounds during print. - by IllDante - 05-09-2020, 01:19 PM
RE: Cracking sounds during print. - by fromFDMtoSLA - 05-10-2020, 12:13 AM
RE: Cracking sounds during print. - by IllDante - 05-10-2020, 08:39 AM
RE: Cracking sounds during print. - by fromFDMtoSLA - 05-10-2020, 08:55 AM
RE: Cracking sounds during print. - by IllDante - 05-15-2020, 12:36 PM
|
Users browsing this thread: 1 Guest(s)