|
Cracking sounds during print.
|
05-10-2020, 08:39 AM
(05-10-2020, 12:13 AM)fromFDMtoSLA Wrote: remove the moisture and check the FEP about a damages. Somtimes there are some small holes in the FEP, so your "moisture" can be resin. Moisture was from ISO, when I cleaned everything (the underside of the tank), I did not dry it properly, so some moisture was trapped under there - and since the seal was airtight, the alcohol could not escape. All good now though. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Cracking sounds during print. - by IllDante - 05-07-2020, 10:19 AM
RE: Cracking sounds during print. - by fromFDMtoSLA - 05-07-2020, 10:29 PM
RE: Cracking sounds during print. - by IllDante - 05-09-2020, 01:19 PM
RE: Cracking sounds during print. - by fromFDMtoSLA - 05-10-2020, 12:13 AM
RE: Cracking sounds during print. - by IllDante - 05-10-2020, 08:39 AM
RE: Cracking sounds during print. - by fromFDMtoSLA - 05-10-2020, 08:55 AM
RE: Cracking sounds during print. - by IllDante - 05-15-2020, 12:36 PM
|
