06-03-2020, 03:34 PM
Hi All - weird problem, hopefully, someone can shine some light on.
my Mars has been running perfectly until this evening,
I went to print a file and when the plate went into the tank for the first layer, the machine started making a loud sound. It's not a good sound so I cancelled it immediately.
I then took the tank off, levelled the plate and tried again with the same result.
its the same noise you get if you bring the plate up too high and it hits its end stop.
Any ideas would be appreciated - Thanks
my Mars has been running perfectly until this evening,
I went to print a file and when the plate went into the tank for the first layer, the machine started making a loud sound. It's not a good sound so I cancelled it immediately.
I then took the tank off, levelled the plate and tried again with the same result.
its the same noise you get if you bring the plate up too high and it hits its end stop.
Any ideas would be appreciated - Thanks