07-12-2020, 08:49 PM
(06-13-2020, 01:49 AM)cliffyk Wrote: I had build plate adhesion problems with my Mars purchased earlier this year and used a 320 grit disk in a Dewalt random orbit sander to "break" the glaze on the plate's finish--just 3 to 4 seconds of contact, problem solved. You could probably do it manually as well. You don't need to (and shouldn't) remove any of the finish, just deglaze it...
So basically just take off the top layer of "shine" on the plate? I came onto the thread tonight wondering the same thing as I am getting no adhesion to the plate and after about 20 minutes or so there is a small "cake" of cured resin on the fep at the bottom of the vat.