07-03-2020, 04:21 AM
Hello,
made few prints, the problem I am facing is consistency - some prints coming out outstanding and some just poor.
The problem is sticking to the plate, some prints did not stick at all, and some piled of partially and disfiguring prints.
I know "sticking to the plate" problem is something that eradicated with an experience, but please suggest relevant to Mars solutions.
Also please advise how tightly stretched I need to have FEP, very tight or shell I leave a bit loose ?
made few prints, the problem I am facing is consistency - some prints coming out outstanding and some just poor.
The problem is sticking to the plate, some prints did not stick at all, and some piled of partially and disfiguring prints.
I know "sticking to the plate" problem is something that eradicated with an experience, but please suggest relevant to Mars solutions.
Also please advise how tightly stretched I need to have FEP, very tight or shell I leave a bit loose ?