08-02-2020, 05:17 PM
hi,
so ive had my printer for a few months now and for about the last month i can not get a single print to work unless i print it directly to the print and even then it gets little distorted waves in it if its tall.
ive been printing the same stuff and now suddenly it cant seem to print them. the print fails at the supports even on heavy. when i started i could use medium and light, then only heavy, now the supports fail even after using heavy supports. any ideas? ive contacted elegoo multiple times saying i think my plate is moving(and it is to much for the supports to hold on) or my usb is going in and out making it read for half the print and then stop reading the usb.
point me in the right direction ive gone thru two things of elegoo abs with nothing to show for it.
so ive had my printer for a few months now and for about the last month i can not get a single print to work unless i print it directly to the print and even then it gets little distorted waves in it if its tall.
ive been printing the same stuff and now suddenly it cant seem to print them. the print fails at the supports even on heavy. when i started i could use medium and light, then only heavy, now the supports fail even after using heavy supports. any ideas? ive contacted elegoo multiple times saying i think my plate is moving(and it is to much for the supports to hold on) or my usb is going in and out making it read for half the print and then stop reading the usb.
point me in the right direction ive gone thru two things of elegoo abs with nothing to show for it.