11-17-2020, 02:34 PM
Hi Cliffyk, thanks for the comment, I'll try to disassemble the plate.
I suspect it will not work for this reason
what I saw in my print has been that:
- tightening lightly the screws, stopping when I feel resistance.... the print starts... and it ends with the plate loose moving around and a curved.. deformed print
- tightening more the screws, the plate rotates a bit (this must be what you say I'll flatten the screws)... but again... the print start... and after a while I see the plate loose moving around.. and the print fails ..deformed print...
I think there must be a problem with the direction of the vertical movement for some reason....that pushes the plate in a non flat way... causing the screws to untighten and the position goes bananas whot the print.
I'm not an expert, I have my Mars 2 Pro a few days... but this is the feeling, observing how lose is the plate when I stop the print.
I suspect it will not work for this reason
what I saw in my print has been that:
- tightening lightly the screws, stopping when I feel resistance.... the print starts... and it ends with the plate loose moving around and a curved.. deformed print
- tightening more the screws, the plate rotates a bit (this must be what you say I'll flatten the screws)... but again... the print start... and after a while I see the plate loose moving around.. and the print fails ..deformed print...
I think there must be a problem with the direction of the vertical movement for some reason....that pushes the plate in a non flat way... causing the screws to untighten and the position goes bananas whot the print.
I'm not an expert, I have my Mars 2 Pro a few days... but this is the feeling, observing how lose is the plate when I stop the print.