07-23-2021, 10:01 AM
I got my Mars 2 Pro today and was having exactly this problem.
I did find a solution. Not ideal but it's worked.
I calibrated the plate with the tank on and filled with resin. I'd already been through the piece-of-paper approach a couple of times to no avail.
I loosened the Allen bolts on the plate, pressed home, the plate adjusted.
Next I tightened the bolts (front first then side).
I then took the plate up with 4 presses on 0.1mm.
Back out to the parent menu and hit the button to set Z.
Crossed my fingers, no grinding motor noise and printed the rooks perfectly.
I think the order of button presses is also very important but the piece-of-paper approach just doesn't seem to allow enough room for the FEP sheet.
It's very possible that I just got lucky and I'm bracing myself for plenty of "You cannot do that!"
![[Image: 219376667_140996901496865_19728302714923...e=611FF59F]](https://scontent-lhr8-1.xx.fbcdn.net/v/t1.15752-9/219376667_140996901496865_1972830271492397762_n.jpg?_nc_cat=111&ccb=1-3&_nc_sid=ae9488&_nc_ohc=66pv1s34D3EAX_jF3jd&_nc_ht=scontent-lhr8-1.xx&oh=b94c7d73b435ed7c4691f1cb28232b10&oe=611FF59F)
I did find a solution. Not ideal but it's worked.
I calibrated the plate with the tank on and filled with resin. I'd already been through the piece-of-paper approach a couple of times to no avail.
I loosened the Allen bolts on the plate, pressed home, the plate adjusted.
Next I tightened the bolts (front first then side).
I then took the plate up with 4 presses on 0.1mm.
Back out to the parent menu and hit the button to set Z.
Crossed my fingers, no grinding motor noise and printed the rooks perfectly.
I think the order of button presses is also very important but the piece-of-paper approach just doesn't seem to allow enough room for the FEP sheet.
It's very possible that I just got lucky and I'm bracing myself for plenty of "You cannot do that!"