Elegoo 3D Printers Forum › Elegoo Mars 3D Printer › Getting Started v
Failed Prints after long successes

 
Thread Rating:
  • 0 Vote(s) - 0 Average
Thread Modes
Failed Prints after long successes
VonStrom Offline
Junior Member
**
Posts: 8
Threads: 2
Joined: Jun 2020
Reputation: 0
#6
08-09-2020, 06:38 AM
(08-07-2020, 11:16 PM)cliffyk Wrote:
(08-07-2020, 07:21 PM)VonStrom Wrote: Changed the screen still having failed prints. Im about to boot it out the window

What is the failure mode (holes, deformation/"melting", not releasing from the FEP)?
So at the moment its the entire right  side of the plate is not staying on the plate. it peeling up and the items that are sticking to the middle and left side have deformation
Find
Reply


Messages In This Thread
Failed Prints after long successes - by VonStrom - 08-06-2020, 11:52 AM
RE: Failed Prints after long successes - by VonStrom - 08-09-2020, 06:38 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)