08-31-2020, 02:24 PM
We've just set aside today to try out our new Mars Pro and honestly, no success and we're feeling pretty deflated and like we've wasted our money.
We went simple, we bought a Mars Pro from 3DJake with a deal with three lots of Resin. Followed the instructions to the letter to get started and print the Rook test piece from the supplied CBT file. Both times the result is resin solidifying in the tray with two 4mm thick discs left in the centre.
I'd understand us messing up something complex but we started simple because we want to learn. Any advice to get us going?
We went simple, we bought a Mars Pro from 3DJake with a deal with three lots of Resin. Followed the instructions to the letter to get started and print the Rook test piece from the supplied CBT file. Both times the result is resin solidifying in the tray with two 4mm thick discs left in the centre.
I'd understand us messing up something complex but we started simple because we want to learn. Any advice to get us going?