09-05-2020, 04:49 AM
A few people have had problems with the preloaded rook prints. Reslicing might help.
I had problems with parts sticking to the film rather than the bed. Changing the first layer exposure to 90s seems to ‘bake’ the part to the bed better.
Once I had that sorted, the most common problem I’ve had is parts falling off the support structure. Supports are a balance between the support strength and the strength of the part attachment to the film. The weakest point is where the part attaches to the support so if it fails you need to add more points or increase their size. Both can impact part finish.
I’m currently using Prusa Slicer for support generation and then converting the file to ctb format.
Hope this is of some help!
J
I had problems with parts sticking to the film rather than the bed. Changing the first layer exposure to 90s seems to ‘bake’ the part to the bed better.
Once I had that sorted, the most common problem I’ve had is parts falling off the support structure. Supports are a balance between the support strength and the strength of the part attachment to the film. The weakest point is where the part attaches to the support so if it fails you need to add more points or increase their size. Both can impact part finish.
I’m currently using Prusa Slicer for support generation and then converting the file to ctb format.
Hope this is of some help!
J