10-31-2020, 05:29 AM
(This post was last modified: 10-31-2020, 12:48 PM by plate-of-shrimp.)
Thanks @Van Valen!
11. Resin settings in Lychee were very optimistic. Set Base Layer Time to 60s and Normal Layer Time to 8s.
This yielded a successful test piece (a little cube guy).
12. Created a custom piece in OpenSCAD, exported an STL, imported to Lychee, created .ctb, printed that.
Success. Need to clean it off. Don't start without isopropyl alcohol handy!
11. Resin settings in Lychee were very optimistic. Set Base Layer Time to 60s and Normal Layer Time to 8s.
This yielded a successful test piece (a little cube guy).
12. Created a custom piece in OpenSCAD, exported an STL, imported to Lychee, created .ctb, printed that.
Success. Need to clean it off. Don't start without isopropyl alcohol handy!
ELEGOO Mars 2 Pro
ELEGOO Standard Resin (Gray)
ELEGOO Standard Resin (Gray)