"Move Z axis to zero" button moves plate up, now stuck
|
"Move Z axis to zero" button moves plate up, now stuck
|
07-30-2021, 08:15 AM
There is a red light & a sensor at the bottom of the screw, and a tab off the plate holder that breaks the light beam when it is at the bottom. I had gotten grease on the light or sensor so it thought the plate was already all the way down. Clean that area thoroughly and it should work again.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
"Move Z axis to zero" button moves plate up, now stuck - by improbablegarage - 03-01-2021, 11:41 AM
RE: "Move Z axis to zero" button moves plate up, now stuck - by cliffyk - 03-01-2021, 03:20 PM
RE: "Move Z axis to zero" button moves plate up, now stuck - by improbablegarage - 03-01-2021, 04:50 PM
RE: "Move Z axis to zero" button moves plate up, now stuck - by cliffyk - 03-02-2021, 02:49 AM
RE: "Move Z axis to zero" button moves plate up, now stuck - by improbablegarage - 03-02-2021, 06:05 AM
RE: "Move Z axis to zero" button moves plate up, now stuck - by cliffyk - 03-02-2021, 08:09 AM
RE: "Move Z axis to zero" button moves plate up, now stuck - by KimGlud1976 - 07-30-2021, 08:02 AM
RE: "Move Z axis to zero" button moves plate up, now stuck - by improbablegarage - 07-30-2021, 08:15 AM
|
