03-02-2021, 06:11 AM
For some issues there are a ton of posts all over the internet, but I have a couple that I've not seen elsewhere. I printed this Apple Watch stand. I printed it with the bottom sitting on the build plate.
The top corners near the front were deformed - almost like it was pinched. I suspect this might be due to suction, owing to the orientation. Anyone agree?
Also, along the vertical sides were what can only be described as scratches, the full vertical length, like it was being dragged past something sharp. I have no idea what that may have been from. (I filter my resin when pouring it back inthe bottle).
The top corners near the front were deformed - almost like it was pinched. I suspect this might be due to suction, owing to the orientation. Anyone agree?
Also, along the vertical sides were what can only be described as scratches, the full vertical length, like it was being dragged past something sharp. I have no idea what that may have been from. (I filter my resin when pouring it back inthe bottle).