04-22-2021, 04:33 PM
The motor should turn off once the first layer has begun printing--are you 110% certain the build platform Z-Axis calibration is correct?
|
Won’t start printing
|
|
« Next Oldest | Next Newest »
|
![[Image: 816-20120803-wide800.jpg]](http://www.paladinmicro.com/images/ForumPosts/816-20120803-wide800.jpg)
| Messages In This Thread |
|
Won’t start printing - by Crchisholm - 04-22-2021, 05:54 AM
RE: Won’t start printing - by cliffyk - 04-22-2021, 04:33 PM
|
Users browsing this thread: 1 Guest(s)