07-07-2021, 11:10 AM
Sounds strange to me... I have like 99% success rate and I don't think I'm doing anything special...
WD-40 on the FEP is something I don't think is a good idea, but I haven't tried... I would assume it just mixes up with the resin and impacts its curing properties for the worse. Maybe I'm wrong with that though.
Now on the question why you seem to have so little success rate, without seeing your setup I can only guess. Perhaps bad calibration?
When do the prints fall off the build plate? Do they not stick at all to begin with or do they fall off half way through the print?
WD-40 on the FEP is something I don't think is a good idea, but I haven't tried... I would assume it just mixes up with the resin and impacts its curing properties for the worse. Maybe I'm wrong with that though.
Now on the question why you seem to have so little success rate, without seeing your setup I can only guess. Perhaps bad calibration?
When do the prints fall off the build plate? Do they not stick at all to begin with or do they fall off half way through the print?