Print not sticking to build plate
|
Print not sticking to build plate
|
07-13-2021, 09:57 AM
yeah I thought the supports might be an issue, so I laid the part flat and actualtlly got the part to print in different resins. So it seems like its working for now, though I still had a failure where it did not stick to the plate, are there any adhesives that you could put on the bed, or would that mess up the resin in the tank?
Thanks, Will |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Print not sticking to build plate - by willstef - 06-30-2021, 07:48 PM
RE: Print not sticking to build plate - by mzanetti - 07-07-2021, 11:10 AM
RE: Print not sticking to build plate - by willstef - 07-11-2021, 08:20 AM
RE: Print not sticking to build plate - by mzanetti - 07-12-2021, 03:50 AM
RE: Print not sticking to build plate - by willstef - 07-12-2021, 09:33 AM
RE: Print not sticking to build plate - by mzanetti - 07-13-2021, 06:58 AM
RE: Print not sticking to build plate - by willstef - 07-13-2021, 09:57 AM
|
