07-10-2021, 12:19 PM
So I start a print. Build plate goes down the first time to find the bottom, beeps to acknowledge it, goes up, heads back down to begin, hits the bottom and beeps (sometimes one long beep, sometimes 2 regular beeps), then goes up a short distance and then begins trying to cure layer one. With the build plate no where near the FEP screen where it should be. Anyone know what the issue could be? I’ve re-leveled the thing multiple times and that works just fine. I’ve cleaned the screen and the FEP bowl, re-oiled the build plate thread, shut the whole thing off and unplugged it for a while and then turned it on and tried the whole process again. Still no luck.