09-30-2021, 04:11 AM
(This post was last modified: 09-30-2021, 09:44 AM by Taralan.
Edit Reason: solved
)
Just got my saturn and set it up and set it printing the saturn rooks. What I got was 2 disks on bp, 2 disks on the fep and a diaphinous extremely thin membrane forming a cone / hollow pyramid effect down from the build plate starting around the rooks and spreading out as it got further.. Have been advised that maybe the resin I had to hand needed a different exposure setting, any suggestions / advice?
Edit redid leveling after watching you tube setup, retracted .1mm and paper was still tightly pinned. reset z up by .1, homed and then retried. this time after the .1 rise the paper would pull free with effort. Redid test print and it worked. now all I need to do is work out my new network sending insert memory error
Edit redid leveling after watching you tube setup, retracted .1mm and paper was still tightly pinned. reset z up by .1, homed and then retried. this time after the .1 rise the paper would pull free with effort. Redid test print and it worked. now all I need to do is work out my new network sending insert memory error