Increase Z-axis after print height

[RabbitMedic]

Hello, 

Im not quite sure how to ask my question, so please bear with me. 

After a print ends on my Saturn, the Z-axis raises the build plate up, but most of the time its not enough, and I need to manually move the z-axis. My question is if there is a way to change the instructions to the saturn, and tell it to raise higher after a print finishes.

Thank you!

[billtodd]

There's a M8489 g-code in the machine parameters :

M8489 P1 ; action after printing is completed
; 0: Turn off all motors,
; 1: Does not work after printing,
; 2: After printing is completed, return to zero, the motor is not powered
; 3: After the printing is completed, it drops to the maximum stroke of Z, and the motor is continuously powered.

suggest you standby ready to pull the power if you try any of these:-)