10-21-2021, 02:34 AM
Hi,
I have a weird behaviour with my saturn.
Some times, I have some prints that are not complete. Here is an example
All the prints on the bed are OK except for one that stopped in the middle.
FEP get clogged (this is after performing clean tank)
Is it the FEP which is already dead ? or a slicer issue ? Or something else.
I have done only 3 prints since I last changed the FEP (ok it was huge prints 20cm height)
How frequently do you change the FEP ?
I have a weird behaviour with my saturn.
Some times, I have some prints that are not complete. Here is an example
All the prints on the bed are OK except for one that stopped in the middle.
FEP get clogged (this is after performing clean tank)
Is it the FEP which is already dead ? or a slicer issue ? Or something else.
I have done only 3 prints since I last changed the FEP (ok it was huge prints 20cm height)
How frequently do you change the FEP ?