Thread Rating:
  • 0 Vote(s) - 0 Average
Upgraded Elegoo Mars $250 + shipping
#1
For sale is an upgraded Elegoo Mars 3D printer. It is in top operating and physical condition, with significant upgrades.

Elegoo's specs are:
  • System: ChiTu L5.5 Series
  • Operation: 3.5 Inch Touch Screen
  • Slicer Software: ChiTu DLP Slicer
  • Connectivity: USB
  • Printing Technology: LED Display Photocuring
  • Light Source: UV Integrated Light(wavelength 405nm)
  • XY Resolution: 0.047mm(2560*1440)
  • Z Axis Accuracy: 0.00125mm
  • Layer Thickness: 0.01-0.2mm
  • Printing Speed: 22.5mm/h
  • Power Requirements: 110-220V, 12V5A 60W
  • Build Volume: 4.72 * 2.68 * 6.1 inches

This printer also has a Jackson (https://jacksonproducts.net/) dual rail Z-axis column, low backlash half-nut, and low height clamp knob (see photo, a $115 upgrade), and has been upgraded to the latest Mars Pro firmware. Also included is an 8 GB USB drive, a second build platform (both have drain brackets), five replacement FEP sheets, spare screws,, scrapers, etc.

The Jackson mast makes it a VERY stable and accurate machine. The LCD shutter has fewer than 20 hours on it.

A BIG bonus is an infrared curing oven (see photos) of my design. built upon a microwave oven chassis (retaining the timer and turntable) using a 30 Watt 405 nm infrared LED for fast post print curing.

I also have a kilogram of gray resin, alcohol and print cleaning supplies.

The latest Chitubox free slicing software (https://www.chitubox.com v1.9.1) is their best ever, very stable and quite capable.

Poor health forces sale of this and other electronic equipment (oscilloscopes, signal generators, etc.)--asking $250.00 plus actual shipping cost or reasonable offer for the printer--ask about other stuff.

platen #1 and Jackson dual mast:
[Image: MarsCL-00.jpg]

Mars Pro firmware
[Image: MarsCL-01.jpg]

platen #2 and Jackson dual mast:
[Image: MarsCL-02.jpg]

Jackson dual mast:
[Image: MarsCL-03.jpg]

Jackson upgraded half-nut:
[Image: MarsCL-04.jpg]

Curing chamber lamp:
[Image: Mychamber_LED.jpg]

Curing chamber ON:
[Image: Mychamber_LED_ON.jpg]

ditto;
[Image: Mychamber_LED_ON_bright.jpg]
-cliff knight-
[Image: 816-20120803-wide800.jpg]
paladinmicro.com
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)