Thread Rating:
  • 0 Vote(s) - 0 Average
change screen for a monocrhome?¿
#1
Question 
Hello, I have a mars (1) with which I have been able to see plate v2 type C.
[Image: Whats-App-Image-2022-03-05-at-3-48-30-PM.jpg]
I would like to change the screen for a monochrome one, in order to reduce printing times (in this machine I have them at a height of 0.05mm 10 seconds).

I have seen the following screen:
fhd mono lcd
I think it is compatible with my board, but I think I have to change the firmware...
my questions are:

If I change the firmware and then I want to go back to my old screen, what firmware should I put...

and if there is a place to compare miniatures printed with the two screens... since the mono one I think has less resolution... and I usually use it to print wargame miniatures like warhammer...

Thank you.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)