06-07-2022, 03:13 PM
Hello dear 3D-Printer Freaks ,
Sorry if my english is a bit off im not native speaker.
So recently i bought a second hand Saturn 4k from ebay. Everything worked great. After like 2 weeks i bought a detacheable magnetic plate so i can get the prints off the buildplate more easy. I installed the Plate by 3D-jake like descibed. Then leveled normally. Now i tried to print a plate i designed in solid edge the measurements are 60mm x 80mm and 1mm thick. But the Plates are double as thick as they should be (60mm x 80mm x 2mm).
So i releveled the plate again.... same problem.
Then i leveled again but set the z-axis to 0 after tightening the screws. But nothing changed.
The files are totally ok. I am now using the newest version of chitobox. Had the same problem yesterday before updating the problem.
I hope you can help me.
Sorry if my english is a bit off im not native speaker.
So recently i bought a second hand Saturn 4k from ebay. Everything worked great. After like 2 weeks i bought a detacheable magnetic plate so i can get the prints off the buildplate more easy. I installed the Plate by 3D-jake like descibed. Then leveled normally. Now i tried to print a plate i designed in solid edge the measurements are 60mm x 80mm and 1mm thick. But the Plates are double as thick as they should be (60mm x 80mm x 2mm).
So i releveled the plate again.... same problem.
Then i leveled again but set the z-axis to 0 after tightening the screws. But nothing changed.
The files are totally ok. I am now using the newest version of chitobox. Had the same problem yesterday before updating the problem.
I hope you can help me.