06-18-2022, 01:14 PM
(This post was last modified: 06-18-2022, 01:16 PM by danster189.)
Got an issue with my mars 3 where the print starts flawlessly but about 1500 layers in the UV light stops working but the build plate and other aspects seem to carry on leaving half built prints like you see. I know it is not the files fault due to printing smaller scale (60mm height) but the larger ones (100mm height) fail, there are not setting changes in the 2 and there set to default chitubox settings bar slight increased cure times due to FEP sticking.
any advice?
any advice?