09-04-2022, 12:59 AM
Hello together,
I am really new in the field of 3d printing.
Some prints I have done worked very well, espacially when their are very small.
Like some small bits for fantasy gaming - printing without supports.
But if I want to print a 32mm fantasy miniature (with supports) the prints are very terrible
and I do not know why.
I am very confused because the top of the miniature is printed very well, but the bottom is not printed.
I atteched a word documents with my setting in the chitubox and also the settings that I found for the used Eryone Waterable Resin.
Please, help me.
Thank you very much.
Best regards,
Little Fox
I am really new in the field of 3d printing.
Some prints I have done worked very well, espacially when their are very small.
Like some small bits for fantasy gaming - printing without supports.
But if I want to print a 32mm fantasy miniature (with supports) the prints are very terrible
and I do not know why.
I am very confused because the top of the miniature is printed very well, but the bottom is not printed.
I atteched a word documents with my setting in the chitubox and also the settings that I found for the used Eryone Waterable Resin.
Please, help me.
Thank you very much.
Best regards,
Little Fox