02-24-2023, 01:52 PM
(This post was last modified: 02-24-2023, 01:53 PM by toddalanrose.)
I read through many threads and found ones that are close to this issue but have no actual solutions.
I have a Mars 2 Pro and can no longer print anything. My test piece sticks to the FEP and stops printing after the first layer (see pics)
I have a Mars 2 Pro and can no longer print anything. My test piece sticks to the FEP and stops printing after the first layer (see pics)
- Replaced LCD as it stopped working
- Replaced FEP
- Ran Exposure test ( see pic )
- Watched print happen in a dry FEP bed all the way to 100% just fine.
- Updated firmware ( see pic )
- Increased Exposure time from 2.5 to 9 ( see pic )
- Increased Bottom Exposure Time from 35 to 65 ( see pic )
- Tried 3 different resins - ANYCUBIC 405nm SLA UV-Curing High Precision & Rapid Photopolymer Clear Resin, VOXELAB Rapid UV-Curing Resin 405nm Standard Photopolymer Black Resin, and RICH-OPTO UV-Curing 405nm Rapid High Precision Quick Curing Standard Photopolymer Grey Resin
- My garage and resin are at 70 degrees Fahrenheit