02-21-2024, 04:11 PM
(This post was last modified: 02-21-2024, 04:19 PM by WizardPrinter.)
Currently I'm printing some terrain for a dungeons and dragons tabletop game.
The last print had the same issue I occasionally had with the previous prints.
More than half of the printed parts simply fail after about 20%, while others on the print bed develop a large crack, and others are successful. Failed parts have cured resin remained on the FEP.
All printed parts should be the same height in the end.
I'm using the Lycher slicer and added the settings as image. I use the Elegoo ABS-like 2.0 resin.
I hope you can help me ...
The last print had the same issue I occasionally had with the previous prints.
More than half of the printed parts simply fail after about 20%, while others on the print bed develop a large crack, and others are successful. Failed parts have cured resin remained on the FEP.
All printed parts should be the same height in the end.
I'm using the Lycher slicer and added the settings as image. I use the Elegoo ABS-like 2.0 resin.
I hope you can help me ...