05-25-2023, 05:06 PM
(This post was last modified: 05-25-2023, 05:08 PM by dasmatarix.
Edit Reason: added more details
)
Hi there, have printed a little and its been fine, then went to print again after a while of not using it and nothing prints, did the expose test and the LCD is black, there no purple light, but logo is visible (barely).
I haven't done a firmware update or anything like that, I can see that can cause an issue.
Is it broken? I've tried opening it and checking the cables but I don't think any are loose. See below picture, there is one port with LED in its label with nothing plugged in, but no matching uplugged cable.
I did lose the power cable, so I purchased a new one, its a 12v dc power supply input voltage: 100V-240V 50/60Hz; Output: DC 12V 5A (60W) max.
https://www.amazon.com.au/dp/B07MM14TQC?...ct_details
I haven't done a firmware update or anything like that, I can see that can cause an issue.
Is it broken? I've tried opening it and checking the cables but I don't think any are loose. See below picture, there is one port with LED in its label with nothing plugged in, but no matching uplugged cable.
I did lose the power cable, so I purchased a new one, its a 12v dc power supply input voltage: 100V-240V 50/60Hz; Output: DC 12V 5A (60W) max.
https://www.amazon.com.au/dp/B07MM14TQC?...ct_details