07-26-2023, 12:44 PM
It is almost as if the printed part was mirrored from the CAD file/ stl output. If you look at the screen clip of the Chitubox, the part is pictured correctly. The actual printed part in the other picture has the the vertical rectangle with the holes flipped to the left side. I know there is a mirroring function in Chitubox but I've never used it. I presume that would attempt to mirror a second part on the platten. This part is slightly too wide for the platten but I doubt that could cause this to happen.
The part was sliced originally with version 1.9.4 but I've updated to v1.9.5 and image looks the same. I haven't tried to print that yet as I wanted to know if anybody else has experienced something similar.
The Mars firmware is 4.20.3
The part was sliced originally with version 1.9.4 but I've updated to v1.9.5 and image looks the same. I haven't tried to print that yet as I wanted to know if anybody else has experienced something similar.
The Mars firmware is 4.20.3