05-06-2024, 07:20 AM
Hi All,
I'm having some recent issues with my Saturn 3. Out of the box I was printing with no issues then recently the printer will only print on the back half of the build plate, anything on the other half will just have the bottom layers stuck to the fep with noting at all on the plate.
I have changed the fep
Relevelled (many many times)
Tested the screen (it works)
Turned the build plate 180 degrees (still always the front not sticking)
Tried increasing bottom layer exposure (didn't help and the other side prints fine with current settings).
Really at a loss at what else to try as it worked before. I don't think it is temperature exactly half the plate prints perfect every time and I would have thought I'd get issues on everything if that were the case. Is it worth roughing up the laser etched build plate? Currently using Elegoo 8k Standard Grey
I'm having some recent issues with my Saturn 3. Out of the box I was printing with no issues then recently the printer will only print on the back half of the build plate, anything on the other half will just have the bottom layers stuck to the fep with noting at all on the plate.
I have changed the fep
Relevelled (many many times)
Tested the screen (it works)
Turned the build plate 180 degrees (still always the front not sticking)
Tried increasing bottom layer exposure (didn't help and the other side prints fine with current settings).
Really at a loss at what else to try as it worked before. I don't think it is temperature exactly half the plate prints perfect every time and I would have thought I'd get issues on everything if that were the case. Is it worth roughing up the laser etched build plate? Currently using Elegoo 8k Standard Grey