07-03-2024, 11:19 AM
(This post was last modified: 07-03-2024, 11:20 AM by TheBestagon.)
Hey all!
I'm a newcomer to this forum and to resin printers in general, so I'd appreciate some help! I've been using my Saturn 3 12k printer for about 2 months now. This strange warping has been happening on a lot of prints recently and I'm not sure why/how to fix it. Additionally, my prints have contained some discontinuities (picture attached), not sure if that's related.
I make a point to level the bed and define 0 on the z axis in between every print, and that helped for a while. I've included an image with all of the print settings I'm using. My resin is elegoo's Standard 2.0 Photopolymer resin.
Any suggestions would be greatly appreciated! Thanks everyone!
Please tell me if the attachments cannot be viewed.
I'm a newcomer to this forum and to resin printers in general, so I'd appreciate some help! I've been using my Saturn 3 12k printer for about 2 months now. This strange warping has been happening on a lot of prints recently and I'm not sure why/how to fix it. Additionally, my prints have contained some discontinuities (picture attached), not sure if that's related.
I make a point to level the bed and define 0 on the z axis in between every print, and that helped for a while. I've included an image with all of the print settings I'm using. My resin is elegoo's Standard 2.0 Photopolymer resin.
Any suggestions would be greatly appreciated! Thanks everyone!
Please tell me if the attachments cannot be viewed.