Hi there,
First time here and I'm not sure what to do with my problem. I went to print something after I moved into my new place and found that my printer is only lighting up on the right side of the build. When I clean the tank only half of the tank light shows. So either its a loose cable on the inside or something got under the black tap and screwed up the left side circuitry.
any suggestions?
First time here and I'm not sure what to do with my problem. I went to print something after I moved into my new place and found that my printer is only lighting up on the right side of the build. When I clean the tank only half of the tank light shows. So either its a loose cable on the inside or something got under the black tap and screwed up the left side circuitry.
any suggestions?