Thread Rating:
  • 1 Vote(s) - 5 Average
Ethernet Enabled Printing (Support for ChiTuBox 1.4.0 + 1.5.0)
#26
(09-02-2019, 02:48 AM)admin Wrote:
(08-31-2019, 01:41 AM)Matman Wrote: Here's a fun question! So I ran through this setup yesterday ( everything's working great) and I noticed you can toggle between lan and Wi-Fi in the settings. So I was wondering if we now drop a esp8266-01 on the board if it will be supported? I was planning on getting an esp01 for another project anyway I think I'll just order an extra and give it a shot! If anyone has tried this already or has any insight or thoughts on this I would be curious to hear about it. BTW I realize the image attached is an anycubic photon mobo but I couldn't find anything on the Mars hence this post lol

I have tried with one already and it did not work unfortunately.  It pulled an ip address, but chitubox didnt see it as a valid printer. My guess is that its using a cbd branded fw on the module.
well dang that sucks! thanks for the info already ordered them so i guess i'll give it a little tinkering and see what i can come up with.
Elegoo Mars
Elegoo resin (white, black, grey )
Siraya tech ( tenacious, blue, easy orange)
Reply


Messages In This Thread
RE: Ethernet Enabled Printing - by Simoncox - 07-21-2019, 04:47 PM
RE: Ethernet Enabled Printing - by Lecoyote - 07-21-2019, 06:16 PM
RE: Ethernet Enabled Printing - by admin - 07-21-2019, 06:47 PM
RE: Ethernet Enabled Printing - by admin - 07-21-2019, 06:54 PM
RE: Ethernet Enabled Printing (Support for ChiTuBox 1.4.0 + 1.5.0) - by Matman - 09-02-2019, 06:20 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)