03-20-2020, 09:41 PM
Hello everyone! Super excited to have found this thread!
I also have been trying to find more information on how to send files and print through UART. I had connected my Elegoo Mars (one with the newer mainboard that doesn’t have the ethernet port) to my computer with an USB to UART adapter. I’m able to connect but the g-code commands located in the pdf provided in a previous post resulted in unexpected behavior. I tried downloading octoprint and using the plugin, but I’m unsure of how complete the plugin is or how to make it function. Any help on serial control would be greatly appreciated.
Ideally, I would love to use an ESP32 board with a TF card and a camera to handle all of these functions, since I’m not really looking for manual remote control. My hope is to send the file from chitubox to the Mars and immediately start the print job.
Could anyone that has gotten reliable results sending g-code commands through serial (TX-RX pins) help with those settings? Thanks for any help or guidance!
I also have been trying to find more information on how to send files and print through UART. I had connected my Elegoo Mars (one with the newer mainboard that doesn’t have the ethernet port) to my computer with an USB to UART adapter. I’m able to connect but the g-code commands located in the pdf provided in a previous post resulted in unexpected behavior. I tried downloading octoprint and using the plugin, but I’m unsure of how complete the plugin is or how to make it function. Any help on serial control would be greatly appreciated.
Ideally, I would love to use an ESP32 board with a TF card and a camera to handle all of these functions, since I’m not really looking for manual remote control. My hope is to send the file from chitubox to the Mars and immediately start the print job.
Could anyone that has gotten reliable results sending g-code commands through serial (TX-RX pins) help with those settings? Thanks for any help or guidance!