10-01-2019, 01:40 AM
(This post was last modified: 10-01-2019, 01:44 AM by pixelseppa.)
Here are a couple of photos of a Fan Art model done in Zbrush.
Three seperate prints for this model, it's quite large (150mm).
It fitted together quite well just some cleaning up of the support marks to do.
I am still tinkering with the hollow settings in chitubox but overall it works well.
Three seperate prints for this model, it's quite large (150mm).
It fitted together quite well just some cleaning up of the support marks to do.
I am still tinkering with the hollow settings in chitubox but overall it works well.